MAINTENANCE / MODS
Oxygen Sensors:
I installed two new oxygen sensors (before cat).

AC-Delco, #AFS75
Maintenance and Modifications
U-Joints:
I installed two new Precision Universal Joints. These are made by Federal-Mogul in the USA. To remove the old U-Joints, use a torch to melt the factory injected plastic that holds the U-Joint caps in place.

Precision, #534G (Front and Rear)
Front Stabilizer Bar Bushings and End-Link Kit:
I installed two new Stabilizer bar bushings:

GM, #14094462 (QTY: 2)

I installed a new End-Link Kit:

TRW Stabilizer Bar Link Kit
#18250HD
Steering Components:
I replaced the front steering components before getting my alignment.

Moog Tie Rod Ends:
#ES2019RLT (QTY:2)
Left and Right side are the same.



Moog Center Link
#DS899


NAPA Idler Arm
#263-3654 (Made by Dana/Spicer)
Goodyear Gatorback Serpentine Belts:
I installed new Goodyear Gatorback belts. I like the quality of these belts and really like the helical grooves that do a great job of keeping the belt quiet.

Alternator/AC/Water Pump Belt
#4060642
Cooling Fan Belt
#4040372
Ignition Coil:
I replaced the stock ignition coil with the MSD direct replacement coil. This is a drop in replacement with a little higher output than the factory coil.

MSD Ignition
#8231

Note: This is a
single connector
coil for the 1996
only. 1994-1995
uses a dual connector
coil MSD #8226.